That is why I prefer the Makita sander at about 3000 RPM. I believe that the typical 4.5″ angle grinder is a bit too fast and it will wear the woven discs out quickly. I find that the chemical works best in areas that I poured the chemical. It’s important not to mess with the chemical once it’s applied to the surface. If you are working with fiberglass or plastic, skip to the mechanical or blasting methods below. The stripper can damage the gel coat and the epoxy resin that creates the fiberglass structure.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |